FL45-E1000-POE

Surge Protection Devices For Power Over Ethernet

The POE Surge Protectors are rugged and effective surge protectors for ethernet based systems. They provide a high level of protection against power surges caused by lightning and other causes.

Features

• These surge protectors are used to protect expensive equipment from damage caused by electrical surges
• The ultra-sharp clamping response permanently eliminates transients from your POE applications
• They should be mounted as close to the protected equipment
• The all metal case aluminum enclosure and shielded RJ45 connector provide for good EMI noise suppression
• There is an integral ground wire provided which can be connected to a ground for those systems thatrequire a single point ground connection

Specification

• Nominal operating voltage / Un: Data: 3V, PoE: 48V
• Max operating continuous voltage / Uc: Data: 5V, PoE: 56V
• Rated load current / Iload: 1000mA DC
• POE Standard: IEEE802.3af, 802.3at
• Impulse withstand voltage (10/700μs @40Ω or 1.2/50- 8/20μs @42Ω): 1KV Differential Mode, 6KV Common Mode
• Voltage protection level / Up: Data: ≤10V, PoE: ≤600V
• Data transmission rate: 10/100/1000Mbps/li>
• Insert loss / IL: ≤0.5dB
• Response Time: <10ns
• Max Shunt Capacitance: <10pF
• Series resistor/R: 0Ω
• Protective pins: All Pins 1/2, 3/6, 4/5, 7/8
• Protection Mode: Differential & Common Mode X-X,X-G
• I/O Port: RJ45(with Shield)
• Case material: Aluminium
• Inflammability class: UL94 V0
• Degree of protection: IP20
• Temperature Range: -20 ℃ to +60 ℃
• Operating Humidity: 5% to 95% noncondensing
• Size (L x W x H): 83x25x25mm
• Weight: 110g

Warranty: 3 years

Certificates: GB/T 18802.21-2004,IEC61643.21-2012, EN61643.21-2013