OGŁ 0.6/1kV

Power cables 3 and 4-core wires with insulation and rubber tire for rated voltage 0.6 / 1kV for deep-water engines.

It is recommended:

• to use wire in a well at a depth of immersion up to 20m
• to not install cables at a temperature lower than -10 ° C
• that the radius of bending expressed in multiples of the outside diameter of duct D is not less than 5D

It is allowed:

• to use in conductors with veins made of wires with a nominal diameter of 0.31 mm and larger use of a separator made of polyester or paper tape, in which case they do not have to be tinned wires
• Tinning of wires intended only for a layer of a wire directly in contact with the rubber insulation

Construction:

• Working and protective conductors: Copper multi-wire according to PN-EN 60228 class 5 (tinned wires)
• Separator: Polyester film or telephone paper
• Insulation: Made of rubber IZ according to PN-89 / E-29100
• Insulation color:
• 3-wire: blue, black, brown
• 4-wire: green-yellow, blue, black, brown
• Tire: Of type OZ3 rubber according to PN-89 / E-29100
• Tire color: Black

Characteristic:

• Application: For powering electric motors of submersible pumps working in a moderate climate
• Explanation of the letter code of the wire: OGŁ - Copper conductor with insulation and rubber tire (O), for deep water engines (GŁ)
• Example of wire marking:
• 3-wire OGŁ wire for 6/1 kV, 16mm² cross-section
• Wire OGŁ 0.6 / 1 kV 3x16mm² ZN-95 / MP-13-K12 192
• Working temperature: In water and air from -40 ° C to + 60 ° C
• Test voltage: 3 kV - before the test The cable is immersed in water at 20 ± 5 ° C for the duration of:
• 12h - in the case of a full test
• 6h - in the case of an incomplete examination
• Packing: On drums

Compliant with: ZN-95 / MP-13-K12 192

---