Menu
Your Cart

I-2533CS CR

I-2533CS CR
I-2533CS CR
I-2533CS CR
I-2533CS CR
2-3 weeks
I-2533CS CR
I-2533CS CR
I-2533CS CR
I-2533CS CR
I-2533CS CR
  • Stock: 2-3 weeks
  • Brand: ICPDAS
  • Model: I-2533CS CR
1 503,50 zł

Industrial CAN to Fiber Converter, 1 single mode, SC connector.

The I-2533CS series is a local CAN bridge used to establish a connection between two CAN bus system via single mode fiber optic transmission medium. In order to solve the problem between CAN and fiber transmission medium, the I-2533CS series is specially designed for converting the electrical CAN bus signal to fiber optic cables. Besides, the I-2533CS-A/B supports Wavelength Division Multiplexing (WDM) technology so that only a single fiber cable is needed for transmitting bi-directional CAN data. As the I-2533CS-A and I-2533CS-B must be paired because of hardware limitations, this means that the cost of deploying fiber cable can be effectively reduced.

I-2533CS series has three more important features. First, the transmission distance limitation of the CAN bus system will not affected due to the different CAN baud rate. It means that the total CAN bus working distance can be extended. Second, the bus error on one CAN network will not affect the operation of another CAN network. Finally, the two CAN network can communication with each other by using different CAN baud rate for highly flexibility.

Features:

  • Fiber Type: SC; Single mode; 100 Base-FX
  • Maximum transmission distance up to 30 km at any CAN baud rate
  • NXP TJA1042 CAN transceiver
  • 2500 Vrms isolation on the CAN side
  • Supports both CAN 2.0A and CAN 2.0B
  • Fully compatible with the ISO 11898-2 standard
  • Rotary switch for CAN baud rate configuration
  • Build-in switch for 120 Ω terminator resistor
  • Fiber broken line detection
  • Utility tool for CAN message filter configuration
  • The CAN port with the same Group ID can communicate with each other
  • DIN-Rail mount

Manufacturer's warranty: 12 months


General technical parameters
CAN ports 1x CAN
Fiber mode Single-mode
Fiber 1x 10/100Base-FX
Protocol support CAN
Industrial grade
Optoisolation 3000VDC
Operating temperature -25°C to 75°C
Input voltage 10~30VDC
Mount DIN rail

Write a review

Note: HTML is not translated!
Bad Good
1

We know that choosing the right product can be difficult. Get a free consultation with a technical expert and make the right decision!

We use cookies to offer you the best experience on our site. By continuing to browse the site, You are agree to use cookies.